Crown Safe | Clear Elastic Sealant
Bonds quickly with surfaces under extreme weather conditions while still preserving it's original look. Why distort the natural appearance of a chimney crown or roof with other products when Crown Safe applies and finishes clear! The best clear crown repair product available, Crown Safe is a permanent solution for roof and crown leaks!
APPLIES IN EXTREME WEATHER CONDITIONS & TEMPERATURES
No matter the weather on install day, Crown Safe easily applies and adheres to wet, dry, hot or cold surfaces with ease! There's no need for multiple coats, preparation treatments, or gimmicky stunts - Crown Safe is formulated to defend against the worst weather conditions, and never fails when you need it most!
ELIMINATES ROOF & CHIMNEY CROWN LEAKS IMMEDIATELY
Crown Safe is a fibered, brushable sealant with elastic-like properties that provides a permanent solution to costly roof and chimney crown leaks. It's so effective that it will withstand water contact immediately after application!
ONE STEP PROCESS! NO PRIMERS OR PRE-COATS REQUIRED
Spread it and forget it! Crown Safe applies to surfaces easily without the need for any primer products or skim coats. It's the most effective single component crown and roof protection system in the industry! Don't spend more time on the job site than necessary - get it done right, the first time!
NO MORE COSTLY RETURN VISITS FOR FAILED PRODUCTS
Other products simply coat the top of chimney crowns and roofs, and create a thin layer that often fails resulting in costly return visits. Crown Safe is designed to bond with building substrates, filling small cracks and holes, while providing instant protection that won't fail! Enjoy the peace of mind that comes with knowing the job was done right, the first time.
CONVENIENTLY SIZED CONTAINERS
There's nothing worse than carrying over-sized products up ladders, and taking up useful space in your vehicle. That's why Crown Safe is available in a convenient one gallon container for easy handling on and off the job site.
CROWN SAFE INSTALLATION, CLEANING & SAFETY INFORMATION
For best results, areas to be sealed should be cleaned of debris and basically dry, although moderate amounts of dampness will not interfere with adhesion. Remove dust, dirt, or other contaminants by use of rag or brush. For maximum adhesion to heavily oiled or dirty surfaces, areas should be cleaned with a solvent and allowed to dry.
TOOLING & APPLICATION
On surfaces such as metal, concrete, or asphalt, apply Crown Safe with brush, trowel, or putty knife into seams and cracks using crossing strokes. Extend Crown Safe coverage to 3" to 4" beyond problem areas to ensure best seal. Apply Crown Safe at a rate of 1/16" to 1/8" per coat and do not thin coating. Allow 24 hours to fully cure, then inspect and re-coat if necessary. Paint if desired after Crown Safe has cured with latex or most oil-based paints.
Remove Crown Safe from tools before curing. This may be done by scraping and/or use of solvent based cleaners. Cured materials may be removed by cutting with sharp tools. Observe manufacturer’s precautions when using toxic or flammable solvents.
CONTAINS AROMATIC HYDROCARBONS. VAPOR HARMFUL, use only with adequate ventilation. Contents are COMBUSTIBLE, and must be kept away from heat and open flame. To avoid overexposure, open windows and doors or use other means to ensure fresh air entry during interior application and drying. If you experience eye watering, headaches, or dizziness, increase fresh air, or wear respiratory protection. Avoid contact with eyes and skin, and wash hands thoroughly after using. Keep container closed when not in use and do not transfer contents to other containers for storage.
In case of eye contact, flush thoroughly with large amounts of water for fifteen minutes and seek medical attention. For skin contact, wash thoroughly with soap and water. In case of respiratory difficulty, provide fresh air and call physician. If swallowed, call Poison Control Center, hospital emergency room, or physician immediately. DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents that can cause permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents can be harmful or fatal.
This product contains chemicals known to the state of California to cause cancer and birth defects or other reproductive harm. KEEP OUT OF REACH OF CHILDREN. DO NOT TAKE INTERNALLY.
Additional Product Info
Ratings & Reviews
One-Step Process is accurate
by Bob R.
Really worked well. You just brush it on and you're done.
3 thumbs up for the Crown Safe.
Won’t use anything else. The thing I really like is that it stays where you put it. It doesn’t sag or run and make icicles.
Premier crown product
Crown Safe is the premier crown product on the market.
A Pleasure to Use
by Bob - NJ
Crown Safe goes on easy and is a pleasure to use. I’ve used it a few times now and I look forward to using it again.